Commissioning/Starting Up The Device; Display And Operating Elements; Setting The Display After Switch-On - JUMO safetyM TB 08 Betriebsanleitung

V1.00/EN
5

Commissioning/starting up the device

5.1

Display and operating elements

h
Connect the voltage supply, all LEDs and 7-segment displays are lit permanently for 4s (segment test).
When all connections on the device are carried out correctly, it displays the factory limit value AL.
v
If an alarm or error message appears, refer to Chapter 14 „Alarm messages".
5.2

Setting the display after switch-on

v
Chapter 7.6 „C116 Display after switch-on"
Display 4-digit green seven-segment display for number val-
ues at the top
4-digit green seven-segment display for the
parameter display at bottom
LED OK green Valid range
off
LED K1 red
LED KV yel-
low
LED °C, °F white displays the temperature unit
LED TB white Is lit if the device has been configured as a
5 Commissioning/starting up the device
Error occurred
v
Chapter 7.1 „C111 Analog inputs"
v
Chapter 15 „Error messages"
is lit with alarm or error messages
Is lit if the pre-alarm is active
temperature limiter.
16