C115 Switching Behavior - JUMO safetyM TB 08 Betriebsanleitung

V1.00/EN
7.5

C115 Switching behavior

Switching
behavior
0 Inverse
(O-Function)
k
ex-factory
Remark
If the AL limit value is exceeded, the installed relay output K1 switches OFF. The K1 LED is lit
red and the set display value flashes (e.g. INP).
For the temperature limiter, relay output K1 remains in this status even when the measured
value drops below the limit value AL. Only when the "Reset" key is pressed >3sec or a switch
is activated when the binary input is respectively configured, does the relay output K1 switch
on again and the OK LED is lit green.
The temperature monitor automatically switches the K1 relay output ON and the OK LED is
lit green, when the measured value drops below the limit value AL.
Relay output KV active
LED KV lights up yellow
Hys2
Relay output KV inaktive
LED KV off
Pre alarm
Relay K1 aktive
LED OK lights up green
Relay inaktive
LED K1 lights up red
ALLO
7 Configuration level
Pre alarm range
Valid range Alarm range
Ö
P
S
3,15A
Hys1
5 6 7
AL
Limit Value
Measured Value
Ö
P
S
3,15A
5 6 7
Measured Value
ALHI
26