Selecting And Editing Parameters (Plausibility Inquiry For Input Values) - JUMO safetyM TB 08 Betriebsanleitung

V1.00/EN
5.3

Selecting and editing parameters (plausibility inquiry for input values)

In the standard mask, the measured value limit value or the value for the pre-alarm is displayed depending on the configuration.
h
Carry out step 1 ... 4 to edit a value, e.g. limit value AL in this case.
1 Press for more than 2 sec
2 Use to increase the value
or
Use to decrease the value
3 Briefly press
4 Briefly press
value.
The value is saved.
H
If in the parameter level no key is pressed for 30 seconds,
the device automatically returns to the standard mask (timeout) and the value is not saved.
v
see operating overview on the first inner page of this manual.
5 Commissioning/starting up the device
to confirm the
The first value in the parameter level appears
AL flashes
As a control, limit value AL flashes at the top and
bottom of the display.
Use + to return to the standard mask or
return automatically after timeout
18