JVC GY-DV300 Bedienungsanleitung Seite 55

Contents of Settings on the SYSTEM [1/2] Screen
Item
MIC1 INPUT SEL
WIND CUT MIC1
WIND CUT MIC2
+48V MIC1/+48V MIC2
AUDIO MODE
REC MODE
LONG PAUSE TIME
Selects whether the built-in microphone or a microphone connected to
the MIC 1 input connector should be used.
INT : Use this setting when the built-in microphone should be used.
XLR : Use this setting when a microphone connected to the MIC 1 input
connector should be used.
Selects whether or not the wind noise picked up by the internal
microphone or a microphone connected to the MIC 1 input connector is
reduced. (ON/OFF)
Selects whether or not the wind noise picked up by a microphone
connected to the MIC 2 input connector is reduced. (ON/OFF)
Sets whether +48 V power should be supplied to a microphone
connected to the MIC 1 or MIC 2 input connector. (MIC 1 and MIC 2 are
set separately.)
This should only be set to ON when a phantom microphone is used.
Selects the sampling frequency for audio recording (32 kHz or 48 kHz).
* 4 channels are available when the DV format is recorded with 12-bit,
32 kHz sampling, but the GY-DV300 records the CH-1 and CH-2
channels. The GY-DV300 does not allow after-recording.
Selects the recording speed mode.
SP : Standard Play recording mode.
LP : Long Play recording mode (recording time is 1.5 times longer
than in the SP mode.)
* Tapes recorded in the LP mode on the GY-DV300 can only be played
back on this unit.
When playing back on another unit, noise will appear in the picture
and the sound.
Selects the time (minutes) before the tape protection mode (drum
automatically stops rotating) is engaged when the recording pause (the
recording-standby mode) or still mode continues. (3 minutes or 30
minutes). When used in a cold environment, this becomes 3 minutes
regardless of the setting.
Contents of Setting
E-55