Tally Lamp - JVC GY-DV300 Bedienungsanleitung

WARNINGS
Indication
HEAD CLEANING
REQUIRED!
VTR WARNING
(DEW)
VTR WARNING
(HARD)
VTR WARNING
(TAPE)

TALLY lamp

This lamp blinks when the remaining battery voltage becomes low or the remaining tape is near end.
(In shooting mode only)
Blinking Condition
Slow blinking
(1 time per sec)
Fast blinking
(4 timer per sec)
Memo:
The GY-DV300 is a microcomputer-controlled piece of equipment, which may malfunction due to
external noise or interference. In this case, turn the power OFF, and then turn it ON again.
Condition
Displayed in case of video head
clogging. (Head clogging is
detected and indicated during
edit search in the recording
mode and during playback.)
Displayed when condensation
occurs in the GY-DV300.
Displayed when abnormakity
occurs in the GY-DV300.
The tape is cut
• No more remaining battery power.
• Remaining tape time is 3 minutes or less.
• Tape has run out.
• Abnormality in VTR.
VTR operation and remedy
Operation : Continues
Remedy : Clean the head with the
special head cleaning tape.
(
Operation : Attempts to operate are
rejected.
Remedy : Leave the GY-DV300 with
the power turned ON until
the indication disappears.
Operation : Operation stops. All
attempts to operate are
rejected.
Remedy : This condition can be
cancelled by setting the
POWER switch to "OFF"
and then back to "ON"
again. In some cases,
however, the tape may be
damaged. Please consult
the person in charge of
professional video
equipment at your nearest
JVC-authorized service
agent.
Operation : Operation stops.
Remedy : Take out the cassette tape.
Remaining Battery/Tape
See page 10.)
E-101