Universal Cutter; Cleaning And Servicing; Cleaning The Base Unit - Bosch MCM 3 Series Gebrauchsanleitung

en
Loosen blade insert clockwise ( )

and remove from the blender jug.
Clean all parts, see "Cleaning and

servicing".

Universal cutter

Use (depending on model):
– With the blade insert with blender/cutting
blade for cutting and chopping meat,
hard cheese, onions, herbs, garlic, fruit,
vegetables.
– With the blade insert with grinding blade
for grinding and cutting fairly small
quantities of spices (e.g. pepper, cumin,
juniper, cinnamon, dried anise, saffron),
grain (e.g. wheat, millet, linseeds), coffee
and sugar.
m
Risk of injury from sharp blades/
rotating drive!
Do not remove/attach the universal cutter
until the drive has stopped.
Do not touch blades of the blade insert
with bare hands. Clean them with a brush.
Fig. F shows guide values for the maximum
quantities and processing times when
working with the universal cutter.
Fig. 
Put down universal cutter jug with the

opening face up.
Add food, which is to be cut, in the

jug.Note MAX mark on the jug!
Place seal on the blade insert. Ensure

that the seal is positioned correctly.
Important information
If the seal is damaged or not correctly
positioned, liquid may run out.
Insert blade insert (

universal cutter jug and lock anti-
clockwise ( ).
Turn universal cutter over (blade insert

face down).
Attach the universal cutter (arrow on jug

on dot on the appliance) and rotate all the
way clockwise.
Insert the mains plug.

Set the rotary switch to the desired

setting.
18
18
/ ) into the
Note: The longer the appliance remains
switched on, the finer the ingredients are cut.
Recommendations on using the accessories
can be found in the section "Recipes/
Ingredients/Processing".
After using the appliance
Set the rotary switch to 0/off.

Remove mains plug.

Rotate universal cutter anti-clockwise and

remove.
Turn universal cutter over (blade insert

face up).
Loosen blade insert clockwise ( ) and

remove from the universal cutter jug.
Empty jug.

Clean all parts, see "Cleaning and

servicing".

Cleaning and servicing

The appliance requires no maintenance.
Thorough cleaning protects the appliance
from damage and keeps it functional.
An overview of cleaning the individual parts
can be found in Fig. .
m
Risk of electric shock!
Never immerse the base unit in water or
place under running water.
Warning!
Surfaces may be damaged. Do not use
abrasive cleaning agents.
Note: If processing e.g. carrots and red
cabbage, the plastic parts will become
discoloured by a red film which can be
removed with a few drops of cooking oil.

Cleaning the base unit

Remove mains plug.

Wipe the base unit with a damp cloth. If

required, use a little detergent.
Then dry the base unit.

Cleaning the bowl and accessories
m
Risk of injury from sharp blades!
Do not touch blades of the universal blade
with bare hands. Clean them with a brush.
Do not grip the sharp blades or edges of
the cutting discs. Take hold of discs by the
edge only!
Robert Bosch Hausgeräte GmbH