Enabling Or Resetting A Ps/2 Mouse - G&D DVIMUX2-DL-PS/2 Installationanleitung Und Betriebsanleitung

Enabling or resetting a PS/2 mouse

Compared to USB mouses, PS/2 mouses do not support hot plug technology. You
can therefore insert the PS/2 plug during operation, but it may be possible that the
computer does not detect the input device.
To enable or reset the PS/2 mouse, the KVM switch can be used to send a special
command to the computer.
Since the commands differ depending on the mouse type and the installed operating
system, four different setup keys are provided.
NOTE: A PS/2 mouse can only be reset or enabled in the setup mode.
How to enable or reset a PS/2 mouse:
1. Press
Hotkey+Backspace
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the following setup keys to enable or reset the PS/2 mouse:
 enables the PS/2 mouse of a Linux PC
M
I  enables the PS/2 wheel mouse of a Linux PC
 enables the PS/2 wheel mouse with additional keys of a Linux PC
E
R  resets the PS/2 mouse interface of a Windows PC
(default:
Ctrl+Backspace
Configuration
) to enable the setup mode.
G&D DVIMUX2-DL-PS/2 · 30