Configuration
Changing the single hotkey
Press the hotkey and the
KVM switch. Pressing the hotkey and the select key simultaneously enables the
switching of channels.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
NOTE:
The single hotkey
How to change the current hotkey:
1. Press the
Hotkey+Backspace
vate the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to enable a certain hotkey:
enables Ctrl hotkey
Ctrl
enables Alt hotkey
Alt
Alt Gr
enables Alt Gr hotkey
enables Win hotkey
Win
enables Shift hotkey
Shift
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
2. Use the
Arrow
3. Press the
Space
Ctrl
enables Ctrl hotkey
enables Alt hotkey
Alt
enables Alt Gr hotkey
Alt Gr
Win
enables Win hotkey
enables Shift hotkey
Shift
4. Press the
S
17 · G&D DVIMUX2-DL-PS/2
Backspace
key simultaneously to start the setup mode of the
Ctrl
is preset at default.
(default:
« to switch to the setup menu.
#!
or
keys to select the
Arrow
key (repeatedly) to enable a certain hotkey:
key to save your settings.
) simultaneously to acti-
Ctrl+Backspace
entry.
Hotkey