Resetting the defaults
Use this function to reset the defaults of the delay functions (see previous page).
How to reset the defaults:
1. Start the terminal emulator.
2. Load the connection settings of the setup menu and establish the connection.
3. Use the
Arrow
4. Press
to reset the defaults.
Enter
Showing the firmware version
How to show the firmware version in the terminal emulator:
1. Start the terminal emulator.
2. Load the connection settings of the setup menu and establish the connection.
3. Use the
Arrow
The installed firmware version is displayed.
4. Press
Q
to return to the main menu.
or
keys to select
Arrow
or
Arrow
keys to select
.
Set System Defaults
Show System Info
and press
Setup menu
Enter
.
G&D OperatorPanel · 9