Switching Commands - G&D DVIMUX2-DL-PS/2 Installationanleitung Und Betriebsanleitung

Switching between the computers

Switching commands

The following commands are provided for switching the channel:
Command
1!
2!
<!
>!
ADVICE: Use the »
NOTE:
The serial device carries out the command directly after it is sent.
A message (see below) informs the serial device concerning the success or failure
of the switching of channels.
Messages
The KVM switch confirms the successful execution of a command and otherwise
sends a meassage.
Message
In All
[x]
E01
E06
E10
E13
RS232 mode enabled
11 · G&D DVIMUX2-DL-PS/2
Channel
1
2
switch to previous channel
switch to next channel
« command to show the currently accessing channel.
?!
Meaning
switching to channel
invalid channel number (out of range)
channel switching failed
invalid command
invalid value (out of range)
switch mode (RS232) enabled
successful
[x]