(De)activating the switching via step keys
Instead of using hotkeys to switch to one of the channels connected to the KVM
switch, you can also use step keys to switch the channels in ascending or descending
order.
NOTE:
The use of step keys is disabled in the default settings.
After enabling the step keys, you can use the following key combinations to switch
channels in ascending or descending order:
descending:
»back« step key (default:
»forward« step key (default:
ascending:
IMPORTANT:
The active step keys are dependent on the selected select keys (see
page 19). The following table lists the step keys depending on the active select keys.
Select keys
1 ... 2
NUM 1 ... 2
A ... B
F1 ... F2
How to disable/enable the use of step keys:
NOTE:
Use the setup menu to enable or disable the usage of step keys.
1. Use the terminal emulator to establish a connection to the KVM switch.
Now plug the serial data cable into the service socket.
2. Use the
Arrow
3. Press the
Space
Off
[Step-Keys]
4. Press the
key to save your settings.
S
Hotkey+9
Hotkey+0
»Back« step key
9
NUM 9
I
F9
or
Arrow
keys to select the
key (repeatedly) to choose between the following options:
step keys disabled
step keys enabled
)
)
»Forward« step key
0
NUM 0
K
F10
Select Channel via Step Key
G&D DVIMUX2-DL-PS/2 · 24
Configuration
entry.