G&D DVIMUX2-DL-PS/2 Installationanleitung Und Betriebsanleitung Seite 51

Enabling the »Switch« mode
IMPORTANT: The Service port of the KVM switch can be used to operate the setup
menu as well as to switch between the channels with a serial device.
Switching of channels via the serial device is possible only if the
If necessary, change the standard mode (see page 27) of the Service port to this mode if
you want to switch channels via the serial device immediately after starting the KVM
switch.
An alternative to switching to the
operation.
Switching between the computers
Switch mode is to enter the »
Switch mode is active!
! « command during
G&D DVIMUX2-DL-PS/2 · 10