Changing the double hotkey
If the use of double hotkeys is enabled (see page 16), press the double hotkey and the
Backspace
key simultaneously to start the setup mode of the KVM switch. Switching
of channels takes place by pressing the double hotkey and a select key at the same
time.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
How to change the current double hotkey:
1. Requirement: enabling of the double hotkeys (see page 16).
2. Press
Double hotkey+Backspace
ously to enable the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
3. Press one of the setup keys listed below to activate the desired double hotkey:
Ctrl
enables Ctrl+Shift double hotkey
enables Alt+Shift double hotkey
Alt
Alt Gr
enables Alt Gr+Ctrl double hotkey
enables Win+Ctrl double hotkey
Win
enables Shift+Win double hotkey
Shift
1. Requirement: enabling of the double hotkeys (see page 16).
2. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
3. Use the
Arrow
4. Press the
Space
Ctrl+Shift
enables Ctrl+Shift double hotkey
enables Alt+Shift double hotkey
Alt+Shift
Alt Gr+Ctrl
enables Alt Gr+Ctrl double hotkey
Win+Ctrl
enables Win+Ctrl double hotkey
enables Shift+Win double hotkey
Shift+Win
5. Press the
S
key to save your settings.
(default:
#!
« to switch to the setup menu.
or
keys to select the
Arrow
key (repeatedly) to enable the desired double hotkey:
) simultane-
Ctrl+Shift+Backspace
entry.
Hotkey
G&D DVIMUX2-DL-PS/2 · 18
Configuration