Changing The Select Keys - G&D DVIMUX2-DL-PS/2 Installationanleitung Und Betriebsanleitung

Configuration

Changing the select keys

In the default settings, use the enabled select keys
computers that are connected to the KVM switch.
For instance, you can switch to computer 2 by pressing
How to choose a different select key set:
1. Press
Hotkey+Backspace
the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys shown below to activate the desired set of select
keys to switch between computers 1 to 2:
 enables select keys 1 and 2
1
NUM 1  enables select keys NUM 1 and NUM 2
Z  enables select keys A and B
 enables select keys F1 and F2
F1
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter »
2. Use the
Arrow
3. Press the
Space
switch between computers 1 to 2:
1 ... 2  enables select keys 1 and 2
 enables select keys NUM 1 and NUM 2
NUM 1 ... 2
 enables select keys A and B
A ... B
F1 ... F2  enables select keys F1 and F2
4. Press the S
19 · G&D DVIMUX2-DL-PS/2
(default:
« to switch to the setup menu.
#!
or keys to select the
Arrow
key (repeatedly) to enable the particular set of select keys to
key to save your settings.
1 and
Hotkey+2
) simultaneously to enable
Ctrl+Backspace
Select Keys
2 to switch between the
(default:
Ctrl+2
entry.
).