Reset Button; Resetting The Default Settings - G&D DVICenter DP32 Installationsanleitung

Reset button

The Reset button is placed between the Identification LED and the RS 485 interface on
the front panel of the central module.
This button allows you to reset the default settings and disable the netfilter rules.
NOTE: To prevent you from pressing the button by accident, you are required to
use a thin, pointed object for pressing the button.

Resetting the default settings

Pressing and holding the button during the booting process resets the default settings
of the central module.
NOTE: After the function has been carried out, the default settings of the central
module do apply again. However, the configured assignment of the Dynamic Ports
and the purchased premium functions remain unaltered.
How to reset the default settings of the central module:
1. Turn off both power packs of the central module.
2. Press and hold the Reset button on the front panel of the device.
3. Keep the button pressed and turn the device on.
4. Release the button when the green Switch-LED starts blinking.
NOTE: You can also use the Config Panel web application to reset the default settings.
Central Module » Reset button
G&D DVICenter DP32 · 12