Establishing A Connection In The Terminal Emulator; Configuration Settings; Adjusting The Bit Rate Of The Rs232 Socket - G&D OperatorPanel Installationanleitung Und Betriebsanleitung

Setup menu

Establishing a connection in the terminal emulator

NOTE:
You can access the setup menu with a terminal emulator that is already
installed on the computer (for example HyperTerminal).
If your computer provides no installed terminal emulator, you can use PuTTY, a
software you can download for free.
You can download the program at the following website:
http://www.chiark.greenend.org.uk/~sgtatham/putty/
How to establish a connection in the terminal emulator:
1. Start any terminal emulator (for example HyperTerminal or PuTTY).
2. Establish a new connection in the terminal emulator and enter the following con-
nection settings:
Bits per second:
Data bits:
Parity:
Stop bits:
Flow control
3. Use the supplied service cable to connect the Service interface of the central power
supply to one of the computer's USB interfaces.

Configuration settings

Adjusting the bit rate of the RS232 socket

The serial data connection between the
the same bit rate at both devices.
The following table lists the bit rates that the KVM switches support
Device
DL-MUX4
DVIMUX
DVIMUX8-OSD
TradeSwitch
NOTE: The setup menu of
ured bit rate under
Make sure that the
these switches.
6 · G&D OperatorPanel
115.200
8
None
1
None
OperatorPanel
Supported bit rate(s)
 9.600
 9.600
 115.200
 9.600
and
DVIMUX TradeSwitch
Service RS232 Bitrate . Here you can also change the bit rate.
Switch option under Service RS232 Startup Mode
and the KVM switch requires
 115.200 (standard)
 115.200 (standard)
KVM switches shows the config-
is enabled for