Configuring Global Network Settings; Connecting The Kvm Switch To The Local Network - G&D DL-DVI-MUX2-NT Installation Und Bedienung

Configuring global network settings

Global network settings ensure that the web application is accessible from all sub-
networks, even in complex networks.
How to configure global network settings:
1. Select the section Global settings
2. Enter the following values:
Operating mode
In the DHCP operating mode the following settings are obtained automati-
cally. Entries are not possible.
Hostname
Domain
Gateway:
DNS server 1:
DNS server 2:
3. Click on Save .

Connecting the KVM switch to the local network

How to connect the KVM switch to the local network:
1. Remove the twisted pair cabling between computer and device.
2. Integrate the device into the local network.
.
Enter the desired operating mode:
 Static: Use of static settings.
 DHCP: Obtain settings from a DHCP server.
Enter the hostname of the device.
Enter the domain to which the device should belong.
Enter the IP address of the gateway.
Enter the IP address of the DNS server.
Optionally, enter the IP address of another DNS server.
Initial configuration of the network settings
G&D DL-DVI-MUX2-NT · 18