Installation Of Rls 45 K Control (230 V) - Maico Rv 2 Montageanleitung

15 Installation, electrical connection
4. Wire the connector plug according to the con-
nection and wiring diagram [} 58].
5. Check and ensure that the cable feed into the
mounting sleeve is tight.
B) Inserting the slide-in module into the
mounting sleeve
RV 2 parapet variant (soffit variants without illus-
tration)
1 Slide-in module
2 Retaining bolt
3 Cover frame
4 External air filter, ISO coarse 30% (G2)
1. Check the correct position and fit of the ex-
ternal air filter. This must be attached to the
two heat exchangers with the 4 retaining
brackets.
2. Screw the cover frame to the internal plaster
frame of the mounting sleeve using the 8
screws provided. Align it horizontally and com-
pensate for different plaster thicknesses.
The position of the cover frame can also be
used to slightly adjust the position of the in-
ternal cover.
3. Clean (vacuum out) the inside of the mounting
sleeve.
4. Carefully push the slide-in module into the
mounting sleeve as far as it will go. Pay atten-
tion to the connection cable with the connector
plug. This must be easy to insert.
C) Fit internal air filter and internal cover
1 Internal cover
2 Internal air filter, ISO coarse 45% (G3)
3 Filter frame
1. Insert the internal air filter into the filter frame.
2. Insert the filter frame into the cover frame.
3. Insert the internal cover. This must snap into
the 8 slots of the cover frame.
15.3 Installation of RLS 45 K control
(230 V)
Read the separately enclosed safety
instructions for PushPull ventilation units be-
fore making the electrical connection. Follow
the instructions. Commissioning only permit-
ted by a qualified electrician with fully as-
sembled system components.
DANGER
Danger of short circuit/fire if moisture penet-
rates the control. Short circuits and fire can
lead to serious injuries with fatal con-
sequences.
Ensure a correct, tight cable feed.
DANGER Danger of short circuit/fire in
the event of overload due to incorrect con-
nection or connection of too many units to an
RLS 45 K (serious injury, death).
Connect units in accordance with connection dia-
gram. Observe permissible number of ventilation
units per room air control/power unit.
29