Decommissioning, Dismantling; Environmentally Responsible Disposal; Company Information - Maico Rv 2 Montageanleitung

21 Decommissioning, dismantling

21 Decommissioning, dismantling
DANGER due to electric shock
Observe the safety rules of electrical engineering.
Before taking off covers and before installing the
electrics, shut down all supply circuits, switch off
mains fuse, check that no voltage is present, se-
cure against being accidentally switched back on
and position a visible warning sign.
WARNING
Danger of falling when working at heights.
Serious injuries in the event of a fall. Danger
to persons below the ladder from falling ob-
jects.
When working at heights, use suitable ladders/
climbing aids and ensure that they are stable.
Work in pairs and ensure that you are standing
securely and cannot lose your balance and that
there is no one under the work area. Protect
yourself against falling. Protect the ladder against
bumping, knocking over and tipping.
Decommissioning may only be carried out
by qualified electricians.
1. Switch off the mains fuse and secure it against
being switched on again.
2. Dismantle the individual unit components and
dispose of them properly in accordance with
the following chapter.
38
22 Environmentally responsible
disposal
Packaging and waste equipment contain
valuable, recyclable materials. According
to the Electrical and Electronic Equip-
ment Act and the WEEE Directive, these
must not be disposed of in the domestic
waste. Dispose of them in an environment-
ally friendly manner, in compliance with
the regulations valid in the country where
you are.
For more information → https://
www.maico-ventilatoren.com/ser-
vice/entsorgung.

Company information

© Maico Elektroapparate-Fabrik GmbH. Trans-
lation of the original operating instructions. Mis-
prints, errors and technical changes are reserved.
The brands, brand names and protected trade
marks that are referred to in this document refer
to their owners or their products.