Herunterladen Inhalt Inhalt Diese Seite drucken

Rosenbauer fox 532279-001 Betriebsanleitung Seite 22

Inhaltsverzeichnis

Werbung

Technische Beschreibung
Technical Description
Überhitzungsschutz
K233
Seite - 22 -
22.11.2005 / LSV-GFr / Rev.01
Sicherheitseinrichtungen
Überhitzungsschutz
Dieser mechanische Überhitzungsschutz besteht aus einem
Thermoelement, welches bei einer Löschwassertemperatur
von etwa 60 °C öffnet und bei etwa 55 °C wieder schließt.
Somit wird ein Überhitzen der Pumpe ausgeschlossen. Bei
offenem Ventil strömt das warme Wasser durch einen Schlauch
ins Freie.
Pumpendruckregler (DRE) *
Der Pumpendruckregler wird mittels Tastendruck (K233) akti-
viert (LED leuchtet auf). Der eingestellte Betriebsdruck wird
somit konstant gehalten, unabhängig von der abgenommen
Wassermenge. Mit den + und - Tasten kann der Druck erhöht
bzw. verringert werden. Bei nicht aktiviertem DRE wird mittels
den + und - Tasten die Drehzahl des Motors gesteuert.
Beim Ansaugen begrenzt der Pumpendruckregler die Dreh-
-1
zahl auf 3500 min
. Diese Begrenzung wird ebenfalls aktiv
wenn die Wassersäule abreisst, die Pumpe nicht eingekup-
pelt ist bzw. der Ausgangsdruck zu gering ist.
Bei auftretender Kavitation erscheint die Kavitationsanzeige.
Saftey installations
Overheating protection
This mechanical overheating protection consists of a
thermocouple, which opens at a fire fighting water temperature
of approximately 60 °C and closes with approximately 55 °C.
Thus overheating the pump is excluded. With opened valve
the warm water flows by a hose into the free.
Pump pressure governor (DRE) *
The pump pressure governor is activated by means of
depressing the key (K233) (LED shines on). The adjusted
operating pressure is kept thus constant, removed
independently of the quantity of water. With + and - keys can
be increased the pressure and/or reduced. With not activated
DRE by means of + and - keys the speed of the engine is
steered. When sucking in the pump pressure governor limits
the speed on 3500 rpm. This delimitation likewise active if the
water column tears off, the pump is not coupled and/or the
initial pressure is too small.
With arising cavitation the cavitation announcement appears.
FOX III
© 2005

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis