Maintenance; Maintenance And Servicing Pan; Changing The Exciter Oil; Exciter Oil Change Zi-Rpe60 - Zipper Zi-Rpe60 Betriebsanleitung

17

MAINTENANCE

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death!
 Always stop the machine before carrying out any conversion, adjustment,
cleaning or maintenance work and secure it against unintentional restarting.
17.1

Maintenance and Servicing Pan

The specified intervals refer to working under "normal" operating conditions. Depending on the
load, a change/exchange may also be necessary at an earlier point in time.
What to do?
Check fuel level
Check engine oil level
Control of the operating elements
Check for damaged parts
Checking for loose or lost screws
Change engine oil
Check V-belt
Change exciter oil
Air filter cleaning
Spark plug test
17.2

Changing the exciter oil

17.2.1

Exciter oil change ZI-RPE60

17.2.2

Exciter oil change ZI-RPE90

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE60_ZI-RPE90
W A R N I N G
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.

To drain the exciter oil, remove the drain screw (2) from
the exciter (1) and then tilt the machine. (Note that the
oil can drain more easily when warm.) Then straighten
the machine again and top up with fresh oil.
Recommended oil is 20W20 or similar about 100ml is
needed for a refill.
20W20 oder ähnliches es sind ca. 100ml einzufüllen.
 To drain the exciter oil, loosen the rubber cover (4) on
the machine (3) and remove the drain screw (5) behind
it.

Then tilt the machine. (Note that the oil can drain more
easily when warm.)

Then straighten the machine again and top up with
fresh oil. Recommended oil is 20W20 or similar about
100ml is needed for a refill.
Frequency
before each start-up
before each start-up
before each start-up
before each start-up
before each start-up
first after 20 h, then every 100 h
every 50 h; replacement after 300 h or 1 year
every 200 h
every 50 h, replacement after 300 h or 1 year
every 100 h; replacement after 300 h or 1 year
N O T E
MAINTENANCE
36