Checklist Before Each Use - Zipper Zi-Rpe60 Betriebsanleitung

15.3

Checklist before each use

The use of paint thinners, petrol, aggressive chemicals or abrasives leads to material
damage to the surfaces! Therefore use only mild detergents for cleaning!

Clean the machine and remove dirt and dust if necessary.
 If the air filter is dirty, blow the filter cartridge from the inside by moving a jet of dry
compressed air up and down. Continue until all dust has been removed. Replace the air filter
with a new one if necessary.
 Check the carburettor for external dirt and dust and clean it with dry compressed air if
necessary.
 Check the nuts and bolts for tightness. (Screws or bolts loosened by vibrations can lead to
accidents!)
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE60_ZI-RPE90

Do not forget to tighten the springs (2).
 Fasten the retaining bracket to the machine body
using screws, washers and nuts (3).

Aattach the lifting frame first to the front and then to
the rear (each with screw, spring washer and washer)
(4).

Install the transport device using two screws (5).

Take the throttle cable which is rolled up on the engine
and fix the throttle clamp on the handle (6).

Make sure that the upper throttle lever is set to
minimum ("turtle" symbol).

Finally, secure the throttle cable to the retaining
bracket with two cable ties.
 If necessary, attach the rubber mat to the bottom of
the machine using the metal strips and screws
supplied (7).
N O T E
ASSEMBLY
32