Stopping The Machine; Normal Switch-Off; Emergency Stop - Zipper Zi-Rpe60 Betriebsanleitung

16.4

Stopping the Machine

16.4.1

Normal switch-off


Set the upper throttle lever to "minimum" and let the engine run idle for approx. 3 minutes at
low engine speed.

Then set the engine ON/OFF switch (ignition switch) to the OFF position.

Close the fuel switch.

Wait until the engine has cooled down before storing the machine.
16.4.2

Emergency Stop

In case of danger and/or in an emergency situation, you can quickly switch off the machine with
the speed governor by pushing it completely into the STOP position.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE60_ZI-RPE90
Turn the fuel valve (1) to the "On" position.
Set the engine ON/OFF switch (2) (ignition
switch) also to the "On" position.
NOTE: The closed position of the choke lever (5)
enriches the fuel mixture for starting a cold engine.
The open position (4) provides the correct fuel
mixture for normal operation after starting and for
restarting a warm engine.
Turn the choke lever (3) to the "Closed" position
(5), only for cold engine.
Set the throttle lever (6) to "half throttle" (=
middle position between "fast" (8) and "slow" (7)).
NOTE:: Do not pull the starter rope through to the end
and do not let it rewind after pulling, but only rewind it
quickly.
Grab the starter handle (9) and pull it out slowly.
The resistance becomes strongest at a certain
point. This point corresponds to the compression
point. Let the rope roll back a little from this point
and then pull it out powerfully.
Turn the choke lever to "Open when the engine is
running.
Open throttle further Machine to start
compacting.
OPERATION
35