Changing The Engine Oil; Cleaning The Air Filter; Checking And Replacing V-Belt And Coupling - Zipper Zi-Rpe60 Betriebsanleitung

17.3

Changing the engine oil

17.4

Cleaning the air filter

17.5

Checking and replacing V-belt and coupling

Warning of danger of detection/trapping in!
 Never attempt to check the V-belt while the engine is running. Your hands
could get caught between the V-belt and the clutch. Serious hand injuries are
the result.Warnung vor Erfassungs-/Einzugsgefahr!
If the vibratory power of the machine - regardless of the number of operating hours -
suddenly decreases or stops completely during normal operation, first of all check the
V-belt and clutch.
Loose or worn V-belts reduce power transmission efficiency, result in poor compaction
performance and shorten the service life of the belt itself. Therefore, always check the V-belt
tension at the specified intervals.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE60_ZI-RPE90
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
 Loosen oil drain plug (1) on the rear of the engine.

Open oil tank cap (2). Collect the draining oil in a
collecting container and dispose of it properly!

Tighten oil drain plug again after emptying.

Top up with fresh oil via the filling opening (2) (see
section Checking the engine oil level).
Only use high-quality engine oil, e.g. SAE30, 15W40 or
similar!
A contaminated air filter can contribute to problems starting
the machine, loss of performance during operation and
shorten engine life.
Zipper Machines does not accept any liability for engine
damage caused by failure to clean the air filter regularly.
To clean the air filter, first loosen the wing nut on the air
filter housing, remove the cover (foam filter element (2))
and remove the air filter cassette (paper filter element (1)).
Clean both elements mechanically with a soft brush.
An air filter change is necessary when:
 The engine power drops and the fuel consumption
increases at the same time.
 the oil consumption increases

the starting of the engine becomes more difficult
W A R N I N G
N O T E
If only the air filter cassette is to be cleaned, blow a
dry jet of compressed air from the inside against the
filter until all dust has been removed.
N O T E
MAINTENANCE
37