Storage; Disposal; Troubleshooting - Zipper Zi-Rpe60 Betriebsanleitung

19

STORAGE

If the machine is not used for a longer period of time (>30 days):
Empty the oil tanks or fuel tank.
Remove the spark plug and pour a few drops of engine oil into the cylinder. Using a rope
starter, turn the engine a few times so that the oil is well distributed inside the cylinder.
Clean the spark plug and replace it.
Cover the cooled machine and store it out of the reach of children and unauthorised
persons in a well-ventilated, dry and frost-free environment.
20

DISPOSAL

Observe the national waste disposal regulations. Never dispose of the machine,
machine components or operating equipment in the residual waste. If necessary,
contact your local authorities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he
is obliged in certain countries to dispose of your old machine properly.
21

TROUBLESHOOTING

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
Fault
Motor does not start
Motor stops
Engine does not deliver enough
power:
Insufficient vibration
Machine does not move freely
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE60_ZI-RPE90
W A R N I N G
Possible cause / remedy
 Check On/Off switch and make sure it is positioned to "On".
 Check fuel supply.

Check engine oil level (a sensor prevents starting if oil level is
too low).
 Make sure that the spark plug ignition cable is connected.

Check spark plug

Check carburettor and air filter and make sure they are clean.

Check fuel supply.

Check that the fuel tap is open.
 Check oil levels.
 Check the condition of the air filter.
 Check fuel supply.

Check that the fuel tap is open.

Check the condition of the air filter.

Check throttle position

Check whether the V-belt slips or is lost.
 Check throttle position

Check the underside of the disc for buildup.
STORAGE
40