Changing Presser Feet - Singer 7108 Gebrauchsanweisung

CHANGING PRESSER FEET
Snap-on Presser Feet
The presser feet furnished with your machine
snap on and off a common shank.
Raise needle to highest position by turning the
hand wheel toward you. Raise presser foot.
To Remove and Replace Foot
1a. Press toe of presser foot upward as far as
it will go.
1 b. Then snap down to remove.
2. Centre the new presser foot under the
shank A and lower the presser foot lifter so
that the shank fits the presser foot pin.
3. Press presser foot screw down firmly until
foot snaps into place.
CHANGING THE NEED E
• Raise needle to its highest point by turning
the hand wheel toward you. oosen needle
clamp screw B and remove the needle.
• Insert new needle up into clamp C as far as
it will go. with the flat side of the needle to
the back.
Tighten needle clamp screw.