Changing Presser Feet; Changing The Needle - Singer 7146 Gebrauchsanweisung

lb
2
3
c
-4
la
CHANGING
Snap-on
The presser feet furnished
snap on and off a common
Raise needle to highest position
hand wheel toward you. Raise presser foot.
To Remove and Replace
Press toe of presser foot upward as far as
la.
it will go.
1b. Then snap down to remove.
2. Centre the new presser
shank A and lower the presser foot lifter so
that the shank fits the presser foot pin.
Press presser foot screw down firmly until
3.
foot snaps into place.
CHANGING
Raise needle to its highest
the hand wheel toward you. Loosen
clamp screw B and remove
Insert new needle up into clamp C as far as
it will go. with the flat side of the needle
the back.
Tighten needle clamp screw.
ATTACHING
HEM
Raise presser foot,
screw with a coin
guide between screw and shank of the gen-
eral purpose foot.
Be sure underside
slide plate and front of foot.
Tighten screw with a coin.
PRESSER FEET
Presser Feet
with your machine
shank.
by turning the
Foot
foot under the
THE NEEDLE
point by turning
needle
the needle.
to
BLINDSTITCH
GUIDE
loosen presser foot
and slip blindstitch hem
of the guide clears the
9