Operating - Singer 7108 Gebrauchsanweisung

OPERATING MACHINE WITH
FOOT TREAD E
Attaching Treadle Belt to Machine
• oosen and remove screw A and remove
cover B.
• Disconnect motor plug adaptor C.
• oosen motor bracket screw D one full turn,
raise motor at pulley E and slip motor belt F
off pulley. Remove motor belt from machine,
then tighten bracket screw D.
• Slip treadle belt around top of hand wheel
and into hand wheel groove.
• Replace cover B and tighten screw A
Do not replace adaptor plug C.
Engaging and disengaging drive belt
Disengage belt when not in use.
To engage belt, turn hand wheel toward you
while guiding belt onto large wheel in cabinet
or stand.
To disengage belt, operate treadle slowly and
shift belt off to the right.
OPERATING THE TREAD E
Hold hand whell and loosen hand wheel knob
by turning it toward you Place both feet on
treadle. Turn hand wheel toward you and allow
feet to move freely to follow motion of treadle.
The faster you move your feet, the faster the
machine will sew. Practice this motion until
you are able to regulate speed and are able to
start and keep hand wheel turning toward you.
Then tighten hand wheel knob and prac ­
tice treadle motion with fabric under the
presser foot.