Singer 7108 Gebrauchsanweisung Seite 63

REMOVING AND REP ACING
TOP COVER
• Raise handle.
• To remove top cover, loosen and remove
screws A . and lift it.
• To replace cover, replace and tighten screws.
REMOVING AND REP ACING
BOTTOM COVER
• Tilt machine over on its back and remove
screws C from the bottom cover. Remove
cover from machine.
• Replace by fitting bottom cover to machine.
then replace and tighten screws C
REMOVING FACE P ATE
oosen screw D (do not remove!.
Remove face plate screw E then remove face
plate by drawing it toward you. Replace face
p'ate by sliding top edge of plate under edge
of arm top cover. Tighten screws E and D.
REP ACING S IDE P ATE
Place slide plate in slide way with the front
edge close to. but not covering, the retaining
spring F With a small screwdriver, lift each
end of the spring into each of the side grooves
on the under slide plate. Draw the slide plate
gently toward you to fully engage the spring.
Close slide plate.
61