Singer 7108 Gebrauchsanweisung Seite 13

REMOVING AND REP ACING
NEED E P ATE
• Raise presser foot
• Raise needle to highest position.
• Open slide plate. Place thumb under right
side of needle plate, lift it up and withdraw it
to right
• Replace needle plate under clamping pin A.
push it gently to the left and press down
until tt snaps into place.
NEED E P ATE RAISING SHIM
1 To insert, open the slide plate, place the
raising shim in the slideway and close the
slide plate as shown.
• The raising shim will slide into place under
the needle plate, raising it above the feed.
2. To remove, open the slide plate and pull the
raising shim forward in the slideway.
ATTACHING B INDSTITCH
HEM GUIDE
• Raise presser foot, loosen presser foot
screw with a coin and slip blindstitch hem
guide between screw and shank of the gen ­
eral purpose foot.
• Be sure underside of the guide clears the
slide plate and front of foot.
• Tighten screw with a coin.