Changing The Presser Foot - Singer SE300 Montageanleitung

The presser foot must be changed according to the stitch
CAUTION

CHANGING THE PRESSER FOOT

1. Turn the hand wheel toward you until the needle is at its
highest position.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the presser foot
release lever toward you.
4. Place desired foot with its pin directly under the slot in
presser foot holder.
5. Lower the presser foot lifting lever and the presser foot will
snap into place.
A
CCESSORIES
R P
EMOVING THE RESSER
When attaching presser feet that have their own shank, or
when cleaning the machine, you should remove the presser
foot holder.
1. Remove the presser foot.
2. Loosen the presser foot screw and remove the presser foot
holder.
3. To replace the holder, pull up the holder as far as it will go
from bottom of presser bar.
4. Tighten the presser foot screw securely using the
screwdriver.
NOTE: This sewing machine is a low shank model. When
make sure they are designed for low shank models.
8
F H
OOT OLDER