Singer 7108 Gebrauchsanweisung Seite 39

Applications with straight stitching
DARNING
With Embroidery Hoop
Needle Position. J J.
• Stitch Width
• Stitch ength. 0
• Needle Plate Raising Shim
• No Presser Foot or Presser Foot Shank
• Presser Ban owered
• Insert needle plate raising shim as instruct ­
ed on page 11.
• Trim ragged edges from area to be darned
and centre worn section in embroidery hoop
designed for machine use.
• Position hoop under the needle and lower
presser bar to engage tension. Hold needle
thread loosely with left hand, turn hand
wheel over and draw bobbin thread up
through fabric. Hold both thread ends and
lower needle into fabric. Take a few stitches
to secure.
Snip off thread ends close to fabric.
• Outline area to be darned with straight
stitches for reinforcement.
• Stitch across opening, moving hoop under
needle at a slight angle from lower left to
upper right. Keep lines of stitching closely
spaced and even in length. When opening is
filled, cover area with crosswise lines of
stitching.
This method of controlling fabric movement
with an embroidery hoop may be used to do
embroidering or monogramming.