Stihl MSA 220.0 TC Gebrauchsanleitung Seite 54

English
– Weight in kg: see rating label
®
– Bluetooth radio interface (only for batteries
with ):
– Data connection: Bluetooth
mobile appliance must be compatible with
®
Bluetooth Low Energy 5.0 and support
Generic Access Profile (GAP).
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
– Mobile appliance operating system require‐
ments: Android or iOS (current version or
higher)
21.5 Temperature limits
WARNING
■ The battery is not protected against all ambi‐
ent conditions. If the battery is exposed to cer‐
tain environmental conditions, it may catch fire
or explode. This may result in serious injury to
people and damage to property.
► Do not charge the battery below -20°C or
above 50°C.
► Do not use the chainsaw or battery below
-20 °C or above 50 °C.
► Do not store the chainsaw or battery below
-20°C or above 70°C.
21.6 Recommended temperature
ranges
For optimum performance of the chainsaw and
battery, note the following temperature ranges:
– Charging: 5°C to 40°C
– Use: - 10 °C to + 40 °C
– Storage: - 20 °C to + 50 °C
If the battery is charged, used or stored outside
the recommended temperature ranges, perform‐
ance may be restricted.
54
®
5.1. The
If the battery is wet or moist, allow the battery to
dry for at least 48 h between 15°C and 50°C and
with less than 70% humidity. Higher humidity
may extend the drying time.
21.7 Sound Values and Vibration
Values
STIHL recommends wearing ear defenders.
– Sound pressure level L
to EN ISO 22868: 94 dB(A) The K value for
the sound pressure level is 2 dB(A).
– Sound power level L
EN ISO 22868: 104 dB(A) K-value (uncer‐
tainty) for sound power level is 2 dB(A).
– Vibration level a measured according to EN
hv
ISO 22867
– Control handle: 3.4 m/s². The K value for
the vibration level is 2 m/s².
– Handlebar: 3.0 m/s². The K value for the
vibration level is 2 m/s².
The sound and vibration levels indicated were
measured according to a standardized test
method and can be used as a basis for compar‐
ing electric power tools. The sound and vibration
levels actually occurring may vary from the val‐
ues indicated, depending on the type of applica‐
tion. The sound and vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual sound and vibration stress has
to be estimated. The times when the electric
power tool is switched off and the times when it
is switched on but running under no load can be
taken into account in the estimate.
21.8 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
21 Specifications
measured according
pA
measured according to
wA
0458-007-9801-A