Battery Use And Charging; Replacing The Battery - Companion Ctx Benutzerhandbuch

Caution: Do not force the external power supply cord into the DC input in the incorrect orientation (i.e. upside down). This will
damage the pins and the unit will not charge properly.
Step 5. Plug the AC power cord into the power supply.
Step 6. Once the power connection is secure, plug the AC power cord into a 100-240V grounded outlet. A green light on the power
supply will illuminate (signaling active source power connection). If the laser system is off, the battery will charge provided
the laser system, power supply and wall outlet connections are secure.
Step 7. Charge the unit for approximately 2-2.5 hours.
Recommendation: Fully charge the battery before use. The laser system ships with the battery only partially charged.
2.3.

Battery Use and Charging

Warning:

Do not modify the battery or attempt to insert foreign objects into it.

Do not short circuit the battery, keep away from metallic items.

Do not immerse the battery in water or get the battery wet.
Note: When the external power supply is connected to the laser system, the battery icon will blink green to indicate it is charging the battery.
To determine the battery charge level, the power supply must be unplugged from the rear of the device.
Caution:

Use of this battery in other devices could result in damage to the device or battery.
 The temperature range for charging this battery is 10 °C to 32 C (50 F to 90 F). Do not charge the battery outside of this
range.

Do not store the battery at temperatures above 70C (158F), such as inside a car on a hot day or in direct sunlight; this
may damage the battery.

Avoid dropping the battery. If you suspect the battery or device is damaged, contact Customer Care.

Do not disassemble, open, crush, bend, deform, puncture, shred or burn the battery.
When the laser system is turned on, there is a battery icon in the upper right corner of the display screen. The battery icon will indicate the
amount of charge in the battery. When the unit is connected to AC power (mains/wall outlet), the battery icon will appear fully green and blink
to indicate it is charging. When unplugged, the icon will change color form green to amber to red as the charge is depleted. When the battery
icon is red and blinking, the battery needs to be recharged.
2.4.

Replacing the Battery

Caution: Replace the battery only with an authorized replacement battery. These batteries have been tested in accordance with
applicable safety standards.
Warning: Discarded batteries may create a safety hazard. Before disposal, cover the battery contacts with electrical insulating tape
and contact Customer Care.
If the battery is not charging as expected, contact Customer Care for further troubleshooting to determine if a
replacement is needed.
If it is determined the battery needs to be replaced, follow the below steps for removal and replacement of the
battery.
Step 1. Turn laser off. Turn the laser over and place it on a hard, flat surface. Remove
the battery cover by turning the finger locks. (Figure 9)
Step 2. To remove the old battery, grab the removal strap and pull straight up. (Figure 10)
Step 3. With the arrow on the battery pointing to the front of the unit, insert the new battery
into the battery compartment.
Step 4. With even pressure, fully seat the battery into the
battery compartment.
Step 5. Replace the battery cover and secure the finger locks. The battery cover will fit tightly
to hold the battery in place.
RSR-000929-000 (0) User Manual – CTX
Figure 9
Figure 10
Page 6 of 25