Replacing The Internal Fan - Fronius Galvo 208-240 1.5-1 Serviceanleitung

Replacing the in- Removing the internal fan:
ternal fan
Installing the internal fan:
(2) (1)
(2) (1)
(2) (1)
NOTE! Carefully turn the inverter.
Insert the fan cable (1) for GalvoFIL
6
into the cabling (2)
Close the inverter and insert into the
7
wall bracket (see "Opening and Clo-
sing Device" section)
After commissioning the inverter, carry out
a fan test via the display (see operating in-
structions)
WARNING! Follow the safety
rules (see start of "Safety" chap-
ter)
Remove the inverter from the wall bra-
1
cket and open (see "Opening and Clo-
sing Device" section)
Loosen the fan cable (1) for GalvoPS
2
and pull out
Remove twist protection (2)
3
Remove the internal fan
4
NOTE! Note the air flow direction
in the device.
Insert the internal fan
1
Insert twist protection (2)
2
Thread in the fan cable (1) and insert
3
on GalvoPS
Close the inverter and insert into the
4
wall bracket (see "Opening and Clo-
sing Device" section)
After commissioning the inverter, carry out
a fan test via the display (see operating in-
structions)
101