Fronius Galvo 208-240 1.5-1 Serviceanleitung Seite 108

Installing the GalvoPS:
108
(8) (8)
(9)
Loosen 4 screws 4x9 TX20 (8) on the
7
modules
Insert the screwdriver in the "Remove
8
Print" (9) hole and loosen the GalvoPS
from the heat sink in the direction indi-
cated by the arrow
Remove the GalvoPS
9
Use a clean cloth to loosen residues
10
from the old PCM paste from the heat
sink
NOTE! No residues from the PCM
material must be present
NOTE! When the GalvoPS is re-
turned, the modules must also be
cleaned with a clean cloth.
- Then take the PCM film from
the small parts set
- Position and stretch onto the
modules
- Note the removal of the pro-
tective film!
IMPORTANT! Due to improperly or incor-
rectly placed inductivity contacts it may
happen that the AC / DC modules do not
rest properly on the heatsink.
A thermal overload can result!
Check inductivity contacts whether
11
they are placed correctly on the provi-
ded plastic sockets