Fronius Galvo 208-240 1.5-1 Serviceanleitung Seite 106

106
(2) (2)
(2)
(4) (4)
(3)
Thread in and position the new Galvo-
1
(2) (1)
FIL
Mount the GalvoFIL with 8 screws 4x9
2
TX20 (4)
[2 Nm | 1.48 ft lb]
Mount all cable and plug connections
3
(1-2) on the GalvoFIL
(4) (4)
Insert the PC board holder (3)
3
(3)
The PC board holder must snap com-
4
pletely into place in the DATCOM area
(3)
Insert the Recerbo, close the inverter
5
and insert into the wall bracket (see
"Replacing the Display PC Board
(Recerbo)" and "Opening and Closing
Device" sections)
After commissioning the inverter, carry out
a fan test via the display (see operating in-
structions)