Replacing The Internal Fan - Fronius 10.0-1 Serviceanleitung

Replacing the in- Removing the Internal Fan:
ternal fan
Installing the internal fan:
134
(1) (2)
(1) (2)
WARNING! Follow the safety
rules (see start of "Safety" chap-
ter)
Remove the inverter from the wall bra-
1
cket and open (see "Opening and Clo-
sing Device" section)
Loosen fan cable (1) from the PrimoFIL
2
Loosen the expanding rivet (2) using a
3
slotted screwdriver.
Remove the internal fan
4
(2)
NOTE! Observe the air flow direc-
tion in the device.
Insert the internal fan
1
Press in the expanding rivet (2) using a
2
slotted screwdriver.
Place fan cable (1) on the PrimoFIL
3
Close the inverter and insert into the
4
wall bracket (see "Opening and Clo-
sing Device" section)
After commissioning the inverter, carry out
(2)
a fan test via the display (see operating in-
structions)