Tools And Measurement Devices; Function Overview; Troubleshooting Guide; Replacing Components - Fronius Galvo 208-240 1.5-1 Serviceanleitung

Tools and mea- Here you will find an overview and a description of all the tools necessary to properly ser-
surement devices vice the device. This includes the following tools:
-
-
-
Function over- Contains a brief description which gives an overview of the entire system.
view
Troubleshooting Used to systematically find causes of errors and correct these errors.
Guide
Replacing com- The "Replacing components" chapter describes how to replace components which
ponents -
-

Safety inspection

This section outlines the safety inspection for the device described in this service manual.
It has been structured in compliance with "DIN VDE 0701-0702" and "ÖVE/ÖNORM
E8701-1".
Please also be aware of the requirements and standards relevant to your country, as the
measured values or steps taken during the tests may vary.
Should there be no relevant requirements and standards in your country, Fronius recom-
mends that this test should still be carried out.

Appendix

The "Appendix" chapter contains a complete spare parts list and the circuit diagram of the
device. The circuit diagram is also included in the scope of delivery for the device.
68
Required tools
Measuring and inspection equipment
Auxiliary materials
do not have an accompanying description for their replacement and
which need a complete replacement description