Automatic Shut-Down - Sentiotec Cv 3 Montageanweisung, Gebrauchsanweisung

5 Automatic operation
Continued
5.6 View/Change settings
You can view and change the temperature settings,
heating duration and fan settings while the sauna is
in operation.
5.6.1 Change/View target values
1. Press PROG/OK 8:
In display 5 the respective, current setting will
flash.
2. Use the UP/DOWN buttons 7 to enter the desired
value or to view the set value
3. Press PROG/OK 8:
The new value has been set.
5.6.2 Shutting down the program manually
While heating:
Press START/STOP 6:
- The sauna heater turns off.
- The LED HEAT 3 goes out.
- The control is in standby mode.

5.6.3 Automatic shut-down

The sauna control switches off the heater automatically
once the set heating time (see chapter 7.2) has lapsed.
- You will hear a continuous beep for 10 seconds.
- The LED HEAT 3 goes out.
- The control is in standby mode.
Operating instructions for the user 8
5 Automatic operation
Continued
5.7 After automatic operation
The automatic heating operation (see chapter 7.2) is
always activated only once for reasons of safety.
If you would like activate the sauna control again using
the same settings:
Press UP/DOWN buttons 7 until the LED "Start"
•
C lights up.
The display 5 indicates:
OFF
or the previously set start time.
Press PROG/OK 8 once.
•
The display 5 flashes the automatic start time.
• Press PROG/OK 8 once.
The display 5 stops flashing.
The LED PROGRAM 4 lights up.
If you would like activate the sauna control again using
changed settings:
• see chapter 5 ff.
37