Automatic Sauna Operation - Sentiotec Cv 3 Montageanweisung, Gebrauchsanweisung

5 Automatic operation
5.1 Switching on the sauna control
1. Press ON/OFF 1.
The LEDs 9 - D light up for approx. 5 seconds.
-
The LED TIME D lights up.
-
- The display 5 indicates the current time
(e.g.16:30 hours):
16:30
5.2 Select the start of heating [00:00 - 23:59
hours]
WARNING - Fire hazard:
Prior to turning the sauna control to auto-
matic operation make sure that no com-
bustible objects have been placed on top
of the stove.
1. Press UP/DOWN buttons 7 until the LED START
C lights up:
The display 5 indicates:
OFF
or the value set previously.
2. Press PROG/OK 8:
- The display 5 flashes:
OFF
- or the value set previously.
3. Use the UP/DOWN buttons 7 to enter the desired
value, e.g. [18:00].
- The display 5 flashes:
18:00
4. Press PROG/OK 8:
- The display 5 indicates:
18:00
The LED PROGRAM 4 lights up.
-
- The automatic start time for heating has been set.
Operating instructions for the user 8
5 Automatic operation
Continued
Note - Deactivating the start of heating:
Turn ON/OFF switch 1 off and on again to deactivate
the automatic start of heating. The LED PROGRAM
4 goes out.
5.3 Entering the heating duration (00:00 -
06:00)
1. Press UP/DOWN buttons 7 until the LED TIME
B lights up:
The display 5 indicates (in standby):
-
STOP
- or the remaining operating time while in heating
operation.
2. Press PROG/OK 8:
- The display 5 flashes:
06:00
- or the value set previously.
3. Use the UP/DOWN buttons 7 to enter the desired
value, e.g. [02:30].
- The display 5 flashes:
02:30
4. Press PROG/OK 8:
- The display 5 indicates (in standby):
STOP
or the new heating duration entered during hea-
ting operation.
- The heating duration has been set.
35