Sentiotec CV 3 Montageanweisung, Gebrauchsanweisung Seite 36

5 Automatic operation
Continued
5.4 Entering the temperature (10 - 110° C)
1. Press UP/DOWN buttons 7 until the LED TEMP
A lights up:
The display 5 indicates the current sauna ca-
-
bin temperature, e.g. [22° C]
22°
2. Press PROG/OK 8:
- The display 5 flashes the previously set tempe-
rature, e.g. [90° C]:
90°
3. Use the UP/DOWN buttons 7 to enter the new
desired value, e. g. [95° C]:
The display 5 flashes:
-
95°
4. Press PROG/OK 8:
The display 5 indicates again the current sauna
-
cabin temperature, e.g. [22° C]:
22°
- The temperature has been set.
36
Operating instructions for the user 8
5 Automatic operation
Continued
5.5 Setting the fan [0% - 100% = P]
0 = off / 100 = max.
Note - If no fan was installed:
select the setting 0 P = OFF
1. Press UP/DOWN buttons 7 until the LED VENT
9 lights up:
- The display 5 indicates:
6O P
- or the value set previously.
2. Press PROG/OK 8:
The display 5 flashes:
-
6O P
- or the value set previously.
3. Use the UP/DOWN buttons 7 to enter the desired
value, e. g. [50%]:
- The display 5 flashes:
50 P
4. Press PROG/OK 8:
- The display 5 indicates the set fan speed:
50 P
- The fan speed has been set.