Manual Sauna Operation, Quick-Start - Sentiotec Cv 3 Montageanweisung, Gebrauchsanweisung

4 Manual operation, quick-start
4.1 Switching on the sauna control
1. Press ON/OFF switch 1.
The LEDs 9 - D light up for approx. 5 seconds.
-
The LED TIME D lights up.
-
- The display 5 indicates the current time
(e.g.16:30 hours):
16:30
4.2 Entering the heating duration (00:00 -
6:00)
1. Press UP/DOWN buttons 7 until the LED TIME
B lights up:
The display 5 indicates (in standby):
STOP
or the remaining heating time while in operation.
2. Press PROG/OK 8:
The display 5 flashes:
06:00
or the value set previously.
3. Use the UP/DOWN buttons 7 to enter the desired
value, e.g. [02:30].
The display 5 flashes:
02:30
4. Press PROG/OK 8:
The display 5 indicates (in standby):
STOP
or the new value entered while in heating opera-
tion.
The heating duration has been set.
4.3 Starting the sauna control
1. Press START/STOP 6:
The display 5 indicates the remaining heating
time, e.g.:
02:30
The heater starts heating.
The LED 3 lights up.
34
Operating instructions for the user 8
4 Manual operation, quick-start
Continued
4.4 View/Change settings
You can view and change the temperature settings,
heating duration and fan settings while the sauna is
in operation.
4.4.1 How to change target values
1. Press PROG/OK 8:
In display 5 the respective, current setting will
flash.
2. Use the UP/DOWN buttons 7 to enter the desired
value.
3. Press PROG/OK 8:
The new value has been set.
4.5 Switching off the sauna control
4.5.1 Manually
Press START/STOP 6:
The sauna heater turns off.
The LED HEAT 3 goes out.
The control is turned off.
4.5.2 Automatically
The sauna control switches off the heater automatically
once the set heating time (see chapter 4.2) has lapsed.
- You will hear a continuous beep for 10 seconds.
The LED HEAT 3 goes out.
-
- The control is turned off.