Entering The Time; Sauna Cabin Lighting - Sentiotec Cv 3 Montageanweisung, Gebrauchsanweisung

2

Entering the time

The ON/OFF switch 1 completely disconnects the
sauna control unit from the mains. An internal batte-
ry keeps the time.
The current time has to be set after starting the sau-
na control for the first time.
2.1 Switching on the sauna control
1. Press ON/OFF switch 1:
- The LEDs 9 - D light up for approx. 5 seconds.
The LED TIME D lights up and the display 5
-
indicates the time. (e.g. 12:00 hours)
12:00
2.2 Setting the current time [0 - 24 hrs.]
1. Press PROG/OK 8:
- The display 5 flashes:
12:00
or the time set previously.
The display 5 will flash for 20 seconds. You will
have to start to set the time within these 20 se-
conds because the adjustment mode will lapse
and you will have to select it again.
2. Use the UP/DOWN buttons 7 to enter the desired
value, e.g. [18:00].
Note - High-speed run of values entered:
Press and hold down the UP/DOWN buttons 7 to
trigger a high-speed run of the values entered after
approx. 5 seconds.
3. Press PROG/OK 8:
The display 5 stops flashing.
The time has been set.
Operating instructions for the user 8
3

Sauna cabin lighting

NOTE:
The cabin lighting can be turned on/off independent
of the sauna control function.
1. Switch 2 turns on/off the sauna cabin lighting.
33