Pari eFlow rapid nebuliser system Gebrauchsanweisung Seite 30

J Controller Settings
Step J4 Change sound settings. In the second step you
can change the intensity of the signal tones. By
repeated pressing the ON/OFF button you can
choose between the options: "Default" (Fig. J4a),
"Reduced signal tones" for one single beep for
status feedbacks (Fig. J4b) and "All signal tones
OFF" (Fig. J4c). In the delivered state, the option
"Default" is selected: All signal tones ON.
Step J5 Apply preferred setting. Navigate to your pre-
ferred setting. Wait until the controller automatically
saves the selection after a few seconds. The
controller confirms this with a checkmark (Fig. J5).
Step J6 The controller will shut off. The preferred
settings are now saved.
28
®
eFlow rapid nebuliser system – Questions about your device? Contact your service partner
Fig. J4a
Default
Fig. J4b
Reduced signal tones
Fig. J4c
All signal tones OFF
Fig. J5