G Cleaning And Disinfecting Your Controller, Connection Cord, Power Supply - Pari eFlow rapid nebuliser system Gebrauchsanweisung

G Cleaning and Disinfecting Your Controller, Connection Cord, Power Supply
G Cleaning and Disinfecting Your Controller,
Connection Cord, Power Supply
Step G1 If the controller, connection cord or power supply
needs cleaning, disconnect the connection cord
and power supply from the controller and unplug
the power supply from the wall outlet.
Step G2 To clean, wipe down the controller housing,
connection cord and power supply with a clean,
damp, soft towel.
CAUTION
Do not allow liquid to get inside the controller,
because it may damage the electronics.
Step G3 To disinfect, wipe down the controller housing,
connection cord and power supply with an alcohol-
based disinfecting wipe. To ensure safe application,
follow the instructions for use of the disinfectant
wipe. Effectiveness has been tested using Bacillol
Tissues and Clinell Wipes.
Step G4 Allow the controller, connection cord and power
supply to dry completely before use. Always store
the parts in a dry and clean location.
18
®
eFlow rapid nebuliser system – Questions about your device? Contact your service partner
Fig. G3