Electrical Connection; Cleaning; Transport; Storage - Scheppach EEB1500 Original Bedienungsanleitung

10. Electrical connection

The electrical motor installed is connected and ready
for operation. The connection complies with the ap-
plicable VDE and DIN provisions.
The customer's mains connection as well as the ex-
tension cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables of the same designation.
The printing of the type designation on the connec-
tion cable is mandatory.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for machines with a high
starting current (from 3000 watts)!

11. Cleaning

Attention!
Disconnect the mains plug before carrying out any
cleaning work.
We recommend that you clean the device directly af-
ter every use.
Wipe swarf and dust off the machine from time to time
with a cloth.
Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can pen-
etrate the device interior.

12. Transport

Pull out the mains plug when changing locations dur-
ing work, even for short distances.
Carry the auger exclusively by the handle.
When transporting the auger in a vehicle, it must be
stored safely. To do this, remove the drill (b) from the
motor unit (a) and stow the auger in the original pack-
aging.
m WARNING!
Never use the cable to carry the power tool!

13. Storage

Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C.
Store the power tool in its original packaging.
Cover the power tool to protect it from dust or mois-
ture. Store the operating manual with the power tool.
m WARNING!
Do not store the device outside or in a damp environ-
ment without protection.

14. Maintenance

Attention!
Disconnect the mains plug before carrying out any
maintenance work.
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Data of machine type plate
• Data of motor type plate
www.scheppach.com
GB | 21