Transport; Maintenance; Storage; Electrical Connection - Scheppach GS650 Originalbetriebsanleitung

• Always reassemble the device completely after re-
placing the grinding disc.
Switch the device off and remove the mains plug. Al-
low the device to cool down.
When the grinding disc nut (16) is being tightened or
loosened, the axle has to be held firmly in place with
a pair of pliers or the grinding disc (10) held firm by
hand.
1. Release the grinding wheel nut (16) in the clock-
wise direction (left-handed thread).
2. Remove the grinding wheel (10).
3. Set up a new grinding wheel (10). Screw the grind-
ing wheel nut (16) in the anti- clockwise direction
(left-handed thread).
4. Test run: Before starting work and after each
change of grinding disk, carry out a test run of
at least 60 seconds with no load. Switch off the
equipment immediately if the disk runs lumpy,
substantial vibrations occur, or abnormal noises
are generated.

8. Transport

1. Turn off the power tool before any transport and
disconnect it from the power supply.
2. Protect the power tool from knocks, bumps and
strong vibrations, such as during transport in ve-
hicles.
3. Never use the safety devices for handling or
transporting purposes.

9. Maintenance

m Warning! Prior to any adjustment, maintenance
or service work disconnect the mains power plug!
General maintenance measures
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
down with compressed air at low pressure.
• We recommend that you clean the equipment im-
mediately after you use it.
• Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic
parts in the equipment. Ensure that no water can
get into the interior of the equipment.
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: grinding medium, Carbon brushes,
sharpening wheel, angle gauge, v-belt
* Not necessarily included in the scope of delivery!

10. Storage

Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from
dust and moisture.
Store the operating manual with the electrical tool.

11. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer's mains connection as well as
the extension cable used must also comply with
these regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insula-
tion damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the marking „H05VV-F".
The printing of the type designation on the connec-
tion cable is mandatory.