IFM Electronic Ecomat200 Monitor FD-1 Betriebsanleitung Seite 54

FD-1/FD-1N
MONITOR
7. Test function
The test function allows you to test the switching characteristics of the monitor off-
line after programming.
To activate the test function press the push-button while the operating voltage is
applied to the monitor.
The TEST indicator is displayed and the monitor automatically runs through a defined
frequency range with the outputs switching according to the selected switching
functions and switch points as if a pulse pick-up generated the respective frequency.
Three test parameters are accessible simultaneously. They define the initial value and
the final value of the frequency range as well as the speed with which the monitor
runs through this range.
TS2
Test start frequency on output 2:
Determines the initial value of the frequency range through which the monitor runs
during the test.
Range of values: 1 ... 60000 RPM or 1.0 ... 1000.0 Hz.
Presetting in the factory: 1000 RPM.
TP2
Test stop frequency on output 2:
Determines the final value of the frequency range through which the monitor runs
during the test.
Range of values: 1 ... 60000 RPM or 1.0 ... 1000.0 Hz
Presetting in the factory 1000 RPM.
SW2
Sweep speed on output 2:
Determines the speed with which the monitor runs through the test frequency
range.
Range of values: 1 ... 5 (1 = fastest, 5 = slowest sweep).
Presetting in the factory: 1.
The test parameters are given in the 3rd column of the parameter table (see page
17) with the stepping parameter 11.
You can move within the table as explained above ("Navigating", page 18). Since
the test function is available in the complete parameter table, you can also change
the operating parameters in the same way to optimise the setting of the unit!
The test function is terminated by switching off the unit.
page 54