IFM Electronic Ecomat200 Monitor FD-1 Betriebsanleitung Seite 49

Programming consists of 3 steps:
1. Selection of the parameter,
2. Change and storage of the parameter,
3. Exit the programming mode.
1a) Press the
get to the parameter range 1, press it
once again to get to range 2 and a
third time to get to range 3.
Selection
of the
1
1b) Press the
parameter to
the desired parameter is displayed.
be changed
When the
is pressed for approx. 15s, the unit exits the Display mode and returns
to the Run mode.
2a) Press the
once briefly.
2b) Press the
until the desired parameter value is
displayed.
Press the
Setting of
2
and counts until "0" is reached. Then the next decade starts.
parameter
Set the active decade by pressing the push-button once. Then the preceding
decade is flashing and can be set.
2c) Press the
parameter abbreviation is no longer
flashing and the PRG indicator no
longer displayed
(=acknowledgement / storage).
When you press the
pressed for approx. 15 s, the changed parameters are not stored. The initial
parameter value is re-entered and remains effective. The unit returns to the Dis-
play mode and indicates the old parameter value which is still the actual value.
Press the
Setting of
desired parameter is displayed and con-
additional
tinue with step 2a).
parameters or
3
exiting the
Programming
mode
Press the
push-button briefly to
or push-button until
push-button is pressed for approx. 3s or when no push-button
push-button
or push-button
or push-button and hold it. The smallest decade becomes active
push-button until the
push-button only briefly or when no push-button is
Setting of additional parameters:
or push-button until the
Exiting the Programming mode:
push-button for approx. 3 s.
MONITOR
CH1 RUN
The unit is in the Display mode, the
parameter range is displayed.
CH1 RUN
The actual value and the abbreviation of
the parameter are displayed.
CH1 RUN
The unit is in the Programming mode
(PRG indicator, flashing abbreviation).
CH1 RUN PRG
The new parameter value is displayed.
CH1 RUN
The new parameter value is displayed and
effective.
CH1 RUN
The abbreviation and the actual value of
the selected parameter are displayed.
CH1 RUN
The unit is in the Run mode, the actual
value is displayed.
FD-1/FD-1N
page 49